Types of articles
The journal publishes
full-length scientific articles not exceeding 8 printed pages (20 double-spaced
8 1/2x11-in document pages; font no smaller than 12-point Times New Roman or
Arial); and clinical articles and case reports not exceeding 4 printed pages (10
double-spaced 8 1/2x11-in document pages).
Authors are encouraged to
review these Instructions carefully prior to submitting their manuscripts.
Submission of manuscripts
Submission of manuscripts to
the Journal of International Dental and Medical Research
is via e-mail, also hard copy with electronic record submissions will be
accepted. Submitting authors must provide all information requested during the
submission process, including: corresponding authors contact information;
names, titles (such as associate professor, chairman,), academic degrees
(such asDMD, MS, PhD,) , and affiliations of all authors; short (running)
title; and 2 to 5 keywords. Honorary designations should not be included (eg,
FRCS,, FICD, Diplomate, ABPD, etc). Authors should ensure that the
keywords appear in the U.S. National Library of Medicine Medical Subject
Headings, or MeSH (found at
Both an UNBLINDED and BLINDED
version of the manuscript must be sent to the journal. Tables and graphs should
appear at the end of the main document, while photos and photomicrographs should
be submitted as separate files (.jpg or .tiff format). Prior to submission, the
corresponding author must guarantee that the article has not been published, and
is not being considered for publication elsewhere. Submission of multi-authored
manuscripts implies participation of each of the authors in the preparation of
the paper. Only individuals who have made a significant contribution to the
study or manuscript should be listed as authors. The efforts of others should be
noted in the Acknowledgments section at the end of the manuscript. The
corresponding author should submit the following statement: All authors have
made substantive contribution to this study and/or manuscript, and all have
reviewed the final paper prior to its submission. Authors (including authors of
letters to the editor) are responsible for disclosing all financial and personal
relationships that might bias their work. If such conflicts exist, the authors
must provide additional detail in the letter to the editor. Funding sources for
the work being submitted must be disclosed in the Acknowledgments section
of the manuscript.
Scientific articles should be
organized under the following headings: Abstract, Introduction, Methods,
Results, Discussion, Conclusions, Acknowledgments, and References.
Titles of all papers should not
exceed 15 words.
The Introduction section
should include only pertinent references. When included for a study, the
Methods section should be sufficiently detailed to replicate the study. The
Results section should include only results and not discussion of the
data. The Discussion section should discuss the results, but not repeat
them. The Conclusions section should consist of succinct, numbered
statements that are supported by the results of the study. They should not
repeat the Results section.
submissions must include an abstract. Abstracts should be brief providing the
reader with a concise but complete summary of the paper. Generalizations such as
methods were described should not be used. Scientific articles should have
approximately 200 words .
Key Words: Submitting
authors must provide 2 to 5 keywords from
Editorial style: Papers
will be published in English, using American spelling. Manuscripts must be
submitted with proper English grammar, syntax, and spelling. Authors should
express their own findings in the past tense and use the present tense where
reference is made to existing knowledge, or where the author is stating what is
known or concluded. Footnotes should be avoided and their content incorporated
into the text. Numbers should be represented as digits; only numbers beginning a
sentence should be spelled out. The editors reserve the right to revise the
wording of papers in the interest of the journals standards of clarity and
Units of measure:
Authors should express all quantitative values in the International System of
Units (SI units)
unless reporting English units
from a cited reference. Figures and tables should use SI units, with any
necessary conversion factors given in legends or footnotes. All numbers should
be expressed as digits, and percent values should be expressed as whole numbers.
Laboratory data values should be rounded to the number of digits that refl ects
the precision of the results and the sensitivity of the Measurement procedure.
Statistical tests: The
results of all statistical comparisons should be reported to include the
statistical test value and the associated P value and confi dence
interval, if appropri- ate. If P> P .01, the actual value for P
should be expressed to 2 digits, whether or not P is signifi cant,
unless rounding a signifi cant P value expressed to 3 digits would make
it nonsignifi cant (eg, P=.049, not P P=.05). If P P<.01,
it should P be expressed to 3 digits (eg, P=.003, not P P<.05).
Actual P P values should be expressed unless P<.001, in which case
they P should be so designated. Nonsignifi cant values should not be
expressed as NS. For confi dence intervals, the number of digits should equal
the number of digits in the point estimate. For example, for an odds ratio of
3.56, the 95% confi dence interval should be reported as 1.23, 5.67, not as
Tooth names: The
complete names of individual teeth should be given in full in the text of
articles using the following convention: [primary/permanent]
[maxillary/mandibular] [right/left] [central/lateral or first/second/third]
[tooth type]. Examples: primary maxillary right first molar, permanent
mandibular first molars, but mandibular right second premolar. In tables
these names may be abbreviated by the Universal system (A-T for primary teeth,
1-32 for permanent teeth).
Materials: Any mention of commercially produced materials, instruments,
devices, software, etc, must be followed by the name of the manufacturer and the
manufacturers location in parentheses. Example: ... in an Excel spreadsheet
(Microsoft, Inc,Redmond, Wash).
Abbreviations should be used to make manuscripts more concise. The first time an
abbreviation appears, it should be placed in parentheses following the full
spelling of the term (eg,
permanent first molars (PFMs)
). In manuscripts
using more than three abbreviations, authors should use bold typeface for the
first appearance of each abbreviation.
materials taken from other sources, a written statement from the authors and
publisher giving permission to Journal of International
Dental and Medical Research for
reproduction must be provided. Waivers atric and statements of informed
consent must accompany the manuscript when it is submitted for review. Waivers
should accompany any photograph showing a human subject unless the subjects
features are blocked enough to prevent identifi cation.
Human and Animal Subjects:
Manuscripts of research involving human or animal subjects must state in the
Methods section that the study was approved by an Institutional Review Board
(IRB) or other institutional research ethics committee using language similar to
this institutionally approved study
. IRB approval for human subjects must
also be obtained if the study involved the use of tissues from humans (eg,
extracted teeth), or work produced by humans (eg, systematic analyses and
meta-analyses).When human subjects have been used, the text should indicate that
informed consent was obtained from all participating adult subjects, and parents
or legal guardians of minors or incapacitated adults. If required by the
authors institution, informed assent must be obtained from participating
children at or above the age specified by the institution. The cover letter for
the manuscript must contain a statement similar to the following: The
procedures, possible discomforts or risks, as well as possible benefits were
explained fully to the human subjects involved, and their informed consent was
obtained prior to the investigation.
should be provided at a minimum resolution of 600 dpi as a .tif or .jpg fi le.
Photomicrographs must include a scale labeled with a convenient unit of length
(eg, 50 µm). Figures should be inserted at the end of the main Word document.
Figures should be numbered in Arabic numerals in the order of the first citation
in the text. Legends for each figure must be printed on a separate page. Include
a key for symbols or letters used in the figures.
Figure legends should be
understandable without reference to the text. A key for any symbols or letters
used in the figure should be included. Abbreviations should be explained in a
footnote to the figure. If illustrations, tables, or other excerpts are included
from copyrighted works the author is responsible for obtaining written
permission from the copyright holder prior to submitting the final version of
the paper. Full credit must be given to such sources with a superscript
reference citation in the figure legend. Reference citations in fi gure legends
or captions should follow numerically the reference number in the text
immediately preceding mention of the figure. Figures take up additional page
space and should be limited to those that add value to the text.
Tables: Tables should be
double-spaced, appear on separate pages, and should be titled and numbered in
Arabic numerals in the order of the fi rst citation in the text. Short headings
should appear at the top of each column. Explanatory matter should be placed in
captions, not in the title. For footnotes, use the following symbols in this
sequence: *, , , §. Tables should be understandable without alluding to the
text. Due to space limitations, only tables adding value to the text should be
and other sources of support must be disclosed in the Acknowledgements
section. Personal acknowledgments should be limited to appropriate professionals
who have contributed intellectually to the paper but whose contribution does not
should be relevant to the material presented and identifi ed by superscript
Arabic numerals in the text.
A list of all references should
appear at the end of the paper in numeric order as they are cited in the text.
Journal abbreviations are those used by Index Medicus. Reference style is that
used by the Journal of the American Dental Association (http://www.ada.org/prof/resources/pubs/jada/authors/auth_general.asp
The following are sample
Journal: Stephane A.
Management of Congenital Cholesteatoma with Otoendoscopic Surgery: Case Report.
Turkiye Klinikleri J Med Sci 2010;30(2):803-7.
For journals, list all authors
when there are 6 or fewer; when there are 7 or more, list the first 3, then et
al. Page numbers should be elided where possible. For example: 12-8, 347-51,
Book: Bixler D. Genetic
aspects of dental anomalies. In: McDonald RE, Avery DR, eds. Dentistry for the
Child and Adolescent. 5th ed. Philadelphia: CV Mosby Co;1987:90-116.
Article, report, or
monograph issued by a committee, institution, society, or government agency:
Medicine for the public: Womens health research. Bethesda, Md.: U.S. Department
of Health and Human Services, Public Health Service, National Institutes of
Health; 2001. DHHS publication 02-4971.
World Wide Web:
Ectodermal dysplasia cases and main targets. Available
Accessed January 21, 2008.
Authors citing material from
the World Wide Web should use WebCite (www.webcitation.org), a free
service for org authors who wish to archive their Web references to
ensure that cited Web material will remain available to readers in the future.
Web citations archived on WebCite will not disappear in the future.
Authors should provide direct
references to original sources whenever possible. Avoid using abstracts as
Avoid references to papers
accepted but not yet published, if possible. If such a citation is necessary,
these papers should be cited as being in press, and verification that they
have been accepted for publication must be provided.
Where possible, references of
easily accessible material are preferable to dissertations, theses, and other
unpublished documents. Authors should avoid citing personal communication
unless it provides essential information not available from a public source. In
those cases, the name of
the individual providing the
information and the date of communication should be provided in parentheses in
the text and not as a numbered reference.
Authors should obtain written
permission and confi rmation of accuracy from the source of a personal
communication; this permission should be submitted as a supplementary document
at the time of manuscript submission.
Authors should verify the
accuracy of all references and are responsible for ensuring that no cited
reference contains material that was retracted or found to be in error
subsequent to its publication.
Copyright: All authors
must agree to the terms of copyright transfer as indicated along with the
manuscript submission process.
The Ektodermal Displazi Gurubu
Türkiye owns copyright of any contribution, and its licensees have the right to
use, reproduce, transmit, derivate, publish, and distribute the contribution, in
the journal or otherwise, in any form or medium. Authors will not use or
authorize the use of the contribution without the Ektodermal Displazi Gurubu
Türkiyes written consent, except as may be allowed by world fair use law.
Article Publication Fee
of International Dental and Medical Research does $100 US
charge for publication fee on article.